Dss-networks C5468 Manuel d'utilisateur télécharger pdf (Page 39)

GigMAC-CPCI-3U Network Interface Cards

Gig-CPCI-3U Gigabit Ethernet Switches Board and Driver Users Manual

DSS NETWORKS, INC. DocVersion: 1.2 Page: 39

/* get driver trace buffer */

#define DM_IOCTL_GET_TRC 1

/* get driver statistics */

#define DM_IOCTL_GET_STATS 2

/* get phy registers */

#define DM_IOCTL_GET_PHY_REGS 3

/* get mac registers */

#define DM_IOCTL_GET_MAC_REGS 4

/* set loopback mode */

#define DM_IOCTL_SET_LOOP_MODE 5

Additional arguments:

arg1=0 Disable loopback

arg1=1 Enable loopback

/* read eeprom */

#define DM_IOCTL_READ_EEPROM 6

/* program eeprom */

#define DM_IOCTL_PROG_EEPROM 7

/* get mac address */

#define DM_IOCTL_GET_MAC_ADDR 8

/* dump buffer descriptors */

#define DM_IOCTL_DUMP_BDS 9

/* get mac MIB statistics */

#define DM_IOCTL_GET_MAC_STATS 10

Please also see example code in dmUtil.c for additional information.

10.5 SWITCH CONFIGURATION / MANAGEMENT API

Note: This section is applicable for Model C5468 Gig 3U CPCI switch/interface cards

only.

The following functions are provide a low-level access capability for reading and writing

the configuration and management registers on the embedded switch:

Functions to reset and initialize switch:

STATUS inResetSwitchDevice(int unit, int initialReset);

LOCAL void inLiInitBcm5388(InLiDev *pLiDev);

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 45 46

Pas de commentaire

Dss-networks C5468 Manuel d'utilisateur Page 39